Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019662 2GR-FE ENGINE CONTROL _0106871 ENGINE COOLANT TEMPERATURE SENSOR A

2GR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


a.

Install a new gasket to the engine coolant temperature sensor.


b.

Using a 19 mm union nut wrench, install the engine coolant temperature sensor to the cylinder head sub-assembly.

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)

NOTICE:
·

If the engine coolant temperature sensor has been struck or dropped, replace it.

·

Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




c.

Connect the engine coolant temperature sensor connector.


Hide 11209 4.INSTALL V-BANK COVER SUB-ASSEMBLY

Hide 5.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION