Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › KNOCK SENSOR › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019662 2GR-FE ENGINE CONTROL _0106872 KNOCK SENSOR A

2GR-FE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK CONTROL SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.

Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


a.
A132951C01
0.427,2.99 0.938,2.99 0.938,2.99 1.604,3.688 true 2.177,3.76 2.792,4.469 2.792,4.469 3.01,4.469 true 0.875,0.125 1.208,0.448 0.333,0.323 12 false *A 0.896,1.146 1.229,1.479 0.333,0.333 12 false *B 0.49,1.458 0.802,1.615 0.313,0.156 10 false *a 3.031,1.646 3.26,1.865 0.229,0.219 10 false *b 3.021,1.396 3.292,1.594 0.271,0.198 10 false *c 3.021,0.5 3.25,0.719 0.229,0.219 10 false *b 3.021,0.771 3.292,0.969 0.271,0.198 10 false *c 0.177,2.885 0.417,3.115 0.24,0.229 12 true *A 3.063,4.375 3.333,4.604 0.271,0.229 12 true *B
*A for Bank 1
*B for Bank 2
*a Front of Vehicle
*b 5°
*c 10°


Install the 2 knock control sensors to the cylinder block sub-assembly with the 2 bolts so that the knock control sensor installation position is as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If the knock control sensor has been struck or dropped, replace it.

·

Make sure that the knock control sensor is in the correct position.




b.

Connect the 2 knock control sensor connectors.


Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the knock control sensor.

Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION