89467B
1.REMOVE AIR FUEL RATIO SENSOR (for Bank 2)
Disengage the wire harness clamp.
Disconnect the air fuel ratio sensor connector.
Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly LH.
If the air fuel ratio sensor has been struck or dropped, replace it.
17118
2.REMOVE MANIFOLD STAY
17104
3.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
89467B
4.REMOVE AIR FUEL RATIO SENSOR (for Bank 1)
Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly RH.
If the air fuel ratio sensor has been struck or dropped, replace it.