Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › AIR COOLED OIL COOLER › 2013.12–2016.11
RM3160E _52 Drivetrain _019725 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0107323 AIR COOLED OIL COOLER A

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  AIR COOLED OIL COOLER  INSTALLATION  


PROCEDURE

Hide 32913 1.INSTALL OIL COOLER BRACKET

HINT:

Perform this procedure only when replacement of the oil cooler bracket is necessary.


a.

Temporarily install the oil cooler bracket to the body with the bolt.


b.
C296220N01
1.781,0.781 1.917,1 0.135,0.219 10 true 1 1.552,0.573 1.708,0.771 0.156,0.198 10 true 2

Install the nut and bolt in the order shown in the illustration.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


Hide 32910 2.INSTALL OIL COOLER ASSEMBLY

a.

Install the oil cooler assembly to the oil cooler bracket with the 2 nuts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


b.

Connect the No. 1 oil cooler outlet hose and No. 3 transmission oil cooler hose to the oil cooler assembly and slide the 2 clips to secure them.


Hide 32917 3.INSTALL TRANSMISSION OIL COOLER AIR DUCT

a.
C296221

Install the transmission oil cooler air duct to the oil cooler assembly with the 2 bolts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)

HINT:

Insert the protrusion on the underside of the transmission oil cooler air duct into the bracket hole on the underside of the oil cooler assembly.



Hide 53737B 5.INSTALL FRONT FENDER APRON SEAL LH

Hide 53876A 6.INSTALL FRONT FENDER LINER LH

Hide 51441 7.INSTALL NO. 1 ENGINE UNDER COVER