Home › Drivetrain › MF1A (TRANSFER / 4WD / AWD) › 4WD CONTROL ECU(for RHD)
RM3160E _52 Drivetrain _019685 MF1A TRANSFER / 4WD / AWD _0107529 4WD CONTROL ECU(for RHD) A

MF1A TRANSFER / 4WD / AWD  4WD CONTROL ECU(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55607 3.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 67914 4.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112A 5.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Hide 55436A 6.REMOVE INSTRUMENT PANEL FINISH PANEL END LH

Hide 55303B 7.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 89630A 8.REMOVE 4WD ECU ASSEMBLY

C299029

a.

Disconnect the 4WD ECU assembly connector.


b.
C296254

Using a screwdriver, disengage the 2 claws and remove the 4WD ECU assembly.

NOTICE:

Be careful not to damage the 2 claws.