Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY(for AWD)
RM3160E _52 Drivetrain _019686 DRIVE SHAFT / PROPELLER SHAFT _0107995 REAR DRIVE SHAFT ASSEMBLY(for AWD) A

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY(for AWD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42360A 1.INSTALL REAR DRIVE SHAFT SNAP RING

a.

Install a new rear drive shaft snap ring.

NOTICE:

Face the end gap of the rear drive shaft snap ring downward.



Hide 42340B 2.INSTALL REAR DRIVE SHAFT ASSEMBLY

a.
C296178C01
0,0 0,0 false
V100144

Toyota genuine differential gear oil LT 75W-85 GL-5 or equivalent


Apply Toyota genuine differential gear oil LT 75W-85 GL-5 or equivalent to the area shown in the illustration.


b.
C293516

Align the inboard joint splines, and using a brass bar and a hammer, install the rear drive shaft assembly.

NOTICE:
·

Face the end gap of the rear drive shaft snap ring downward.

·

Do not damage the rear drive shaft oil seal.

·

Do not damage the rear drive shaft inboard joint boot.

·

Make sure to center the rear drive shaft assembly during installation to prevent damage to the rear drive shaft snap ring.



HINT:

Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.



Hide 41110X 5.INSTALL DIFFERENTIAL INSPECTION PLUG

Hide 6.INSPECT FOR DIFFERENTIAL OIL LEAK

Hide 42305 7.INSTALL REAR AXLE CARRIER SUB-ASSEMBLY