Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY › 2013.12–2016.11
RM3160E _52 Drivetrain _019686 DRIVE SHAFT / PROPELLER SHAFT _0107997 PROPELLER SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  REMOVAL  


PROCEDURE

Hide 51442 1.REMOVE NO. 2 ENGINE UNDER COVER

Hide 37100 2.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

a.
C293525C01
2.542,2.344 2.542,2.146 2.542,2.146 2.781,2.146 true 2.813,2.052 3.125,2.25 0.313,0.198 10 false *a
*a Piece of Cloth


Using a 6 mm hexagon socket wrench, loosen the 6 cross groove joint set bolts 1/2 turn.

NOTICE:
·

Put a piece of cloth or equivalent into the inside of the universal joint cover so that the boot does not touch the inside of the universal joint cover.

·

Do not remove the cross groove joint set bolts.




b.
C293526C01
2.385,2.021 2.885,2.021 2.885,2.021 2.885,1.531 true 2.792,2.01 2.792,1.583 true 2.229,1.938 2.542,2.094 0.313,0.156 10 false *a
*a Matchmark


Put matchmarks on the electro magnetic control coupling sub-assembly and propeller with center bearing shaft assembly.


c.
C293527

Remove the 4 nuts and 4 washers.


d.
C293528

Using a brass bar and a hammer, separate the propeller with center bearing shaft assembly.

NOTICE:

Use wire or an equivalent tool to keep the propeller with center bearing shaft assembly.



e.
C293529

Remove the 4 bolts and 4 No. 2 center support bearing washers.

NOTICE:

When removing the bolts and No. 2 center support bearing washers, do not apply excessive force to the universal joint.



f.

Pull out the propeller with center bearing shaft assembly from the transfer assembly.

NOTICE:
·

When removing the propeller with center bearing shaft assembly, do not apply excessive force to the universal joint.

·

During and after the removal of the propeller with center bearing shaft assembly, keep the universal joint angle straight (within 15 degrees).

·

Be careful not to damage the transfer case rear oil seal.




g.
C293530N01
0.781,1.031 1.458,1.031 true 0.458,0.938 0.771,1.125 0.313,0.188 10 true SST

Insert SST in the transfer assembly to prevent oil leakage.

SST
09325-20010  

NOTICE:

Be careful not to damage the transfer extension housing type T oil seal.