75085A
1.REMOVE FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>WHEEL OPENING MOULDING(for Front Side)>REMOVAL
2.REMOVE FRONT WHEEL RH
53851D
3.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Remove the 3 screws and front wheel opening extension pad RH.
53875A
4.REMOVE FRONT FENDER LINER RH
| *a | Clip (A) |
| *b | Clip (B) |
| *c | Clip (C) |
Remove the clip (A).
Remove the 4 clips (B).
w/o Mudguard:
Remove the clip (C).
Remove the 2 grommets.
| *a | Screw (A) |
| *b | Screw (B) |
| *c | Bolt |
Remove the bolt.
Remove the 2 screws (A).
Remove the 5 screws (B) and front fender liner RH.
5.DRAIN WASHER FLUID
Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.
Use a container to collect the washer fluid.
85310C
6.REMOVE WASHER MOTOR AND PUMP ASSEMBLY
Disconnect the connector.
Remove the washer motor and pump assembly as shown in the illustration.