After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
2.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL WITH AIR CONDITIONING CONTROL ASSEMBLY
55422C
3.REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL
55670
4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55680A
5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
6.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 bolts.
Pull the navigation receiver assembly with bracket toward the rear of the vehicle and disengage the 2 claws and 2 clips.
Disconnect each connector and remove the navigation receiver assembly with bracket.
86211J
7.REMOVE NO. 1 RADIO RECEIVER BRACKET
Remove the 3 screws and No. 1 radio receiver bracket.
86212C
8.REMOVE NO. 2 RADIO RECEIVER BRACKET
Remove the 3 screws and No. 2 radio receiver bracket.
86120L
9.REMOVE NAVIGATION RECEIVER ASSEMBLY