Use the same procedure for the RH and LH side.
The procedure described below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
69284D
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
67488C
5.REMOVE REAR DOOR REAR GUIDE SEAL
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
67842E
7.REMOVE REAR DOOR SERVICE HOLE COVER
67858B
8.REMOVE REAR DOOR PANEL PROTECTOR
67872
9.DISCONNECT REAR DOOR WEATHERSTRIP
68152C
10.REMOVE REAR DOOR GLASS RUN
67408E
11.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
68104
12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
69060A
13.REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY
| *a | Release Plate |
Using a T30 "TORX" socket wrench, remove the 3 screws.
Move the rear door lock with motor assembly downward to disconnect it from the release plate of the rear door outside handle frame sub-assembly, and remove the rear door lock with motor assembly.
When reusing the rear door lock with motor assembly:
Remove the door lock wiring harness seal from the rear door lock with motor assembly.
69740D
14.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
69780B
15.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY