Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM3160E _58 Vehicle Interior _019705 DOOR LOCK _0098510 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH side.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 69780B 2.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

Hide 69740D 3.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

Hide 69060A 4.INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY

NOTICE:
·

When reusing a removed rear door lock with motor assembly, replace the door lock wiring harness seal with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

·

Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the rear door lock with motor assembly.



a.

Apply MP grease to the sliding parts of the rear door lock with motor assembly.


b.

When reusing the rear door lock with motor assembly:

i.
B362102

Install a new door lock wiring harness seal to the rear door lock with motor assembly.



c.
B362101C01
2.469,2.75 2.75,2.76 true 2.802,2.667 3.073,2.833 0.271,0.167 10 true *a
*a Release Plate


Connect the rear door lock with motor assembly to the release plate of the rear door outside handle frame sub-assembly, and set it to the rear door panel.

HINT:

Make sure that the release plate of the rear door outside handle frame sub-assembly is securely connected to the rear door lock with motor assembly.



d.

Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 68104 5.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67408E 6.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 68152C 7.INSTALL REAR DOOR GLASS RUN

Hide 67872 8.CONNECT REAR DOOR WEATHERSTRIP

Hide 67858B 9.INSTALL REAR DOOR PANEL PROTECTOR

Hide 67842E 10.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67604 11.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67488C 12.INSTALL REAR DOOR REAR GUIDE SEAL

Hide 13.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Hide 69284D 14.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 16. INITIALIZE POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows)

Hide 17.INSPECT POWER WINDOW OPERATION