Home › Vehicle Exterior › DOOR / HATCH › BACK WINDOW SUPPORT
RM3160E _59 Vehicle Exterior _019719 DOOR / HATCH _0108199 BACK WINDOW SUPPORT A

DOOR / HATCH  BACK WINDOW SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 68961J 1.INSTALL BACK WINDOW STAY BOLT

a.

Clean the bolt hole on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the back window stay bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back window stay bolt.

Torque:
22 N*m (224 kgf*cm, 16 ft.*lbf)


Hide 69942 2.INSTALL BACK DOOR GLASS GUIDE UPPER BRACKET

a.

Clean the bolt holes on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the 2 screws.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door glass guide upper bracket with the 2 screws.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


Hide 3.INSTALL REAR SPOILER SUB-ASSEMBLY

Hide 68940 4.INSTALL BACK WINDOW STAY ASSEMBLY

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the back window stay assembly in order to prevent the piston rod from deforming.



a.

When reusing the back window stay assembly:

i.
B363210

Install the 2 stop rings to the back window stay assembly.



b.
B363211

Install the back window stay assembly.

NOTICE:

Install the back window stay assembly while supporting the back door glass by hand.



c.

Check that the back window stay assembly is engaged to the ball joints and that the back window stay assembly cannot be pulled out.