83320
1.REMOVE FUEL SENDER GAUGE ASSEMBLY
23221
2.REMOVE FUEL PUMP
Disconnect the fuel pump harness from the harness clamp.
Disconnect the fuel pump harness connector.
| *1 | E-ring |
Using needle nose pliers, remove the E-ring from the fuel suction plate shaft.
| *a | Tube |
| *b | Fuel Sub-tank |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws, and remove the fuel filter, fuel pump and spring from the fuel sub-tank.
Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube.
Click hereEngine / Hybrid System>1AR-FE FUEL>FUEL SYSTEM>PRECAUTION
Disengage the claw and disconnect the fuel pump filter hose from the fuel sub-tank.
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.
| *a | Fuel Filter |
| *b | Suction Filter |
Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.
Do not damage the fuel filter.
Do not remove the suction filter from the fuel pump.
Do not use either the fuel pump or suction filter if the suction filter is removed from the fuel pump.
Disconnect the fuel pump harness connector.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
| *a | 5.0 mm (0.197 in.) |
Remove the O-ring and fuel pump spacer from the fuel pump.
Be careful not to damage the sealing surface.
If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm (0.0394 in.) diameter) that is formed as shown in the illustration.