Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT ECU(for LHD)
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0109283 DRIVING SUPPORT ECU(for LHD) A

CRUISE CONTROL  DRIVING SUPPORT ECU(for LHD)  INSTALLATION  


PROCEDURE

Hide 88150A 1.INSTALL DRIVING SUPPORT ECU ASSEMBLY

a.

Engage the claw to install the driving support ECU assembly.


Hide 82877 2.INSTALL ECU INTEGRATION BOX RH

a.

Install the ECU integration box RH with the bolt and 2 nuts.


b.

Engage the 2 clamps.


c.

Connect each connector.


Hide 55303B 3.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 55607 4.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55435A 5.INSTALL INSTRUMENT PANEL FINISH PANEL END RH

Hide 6.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

Hide 62111A 7.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION


Hide 67913 8.INSTALL FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION


Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION