Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT ECU(for RHD) › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0109287 DRIVING SUPPORT ECU(for RHD) A

CRUISE CONTROL  DRIVING SUPPORT ECU(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67914 3.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112A 4.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Hide 5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 55436A 6.REMOVE INSTRUMENT PANEL FINISH PANEL END LH

Hide 55607 7.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55303B 8.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 82878 9.REMOVE ECU INTEGRATION BOX LH

a.
E292363

Disconnect each connector.


b.

Disengage the 2 clamps.


c.
E292364

Remove the bolt, 2 nuts and ECU integration box RH.


Hide 88150A 10.REMOVE DRIVING SUPPORT ECU ASSEMBLY

a.
E292365

Disengage the claw to remove the driving support ECU assembly as shown in the illustration.