This DTC is stored when the multiplex network door ECU detects a malfunction of the power back door unit assembly set RH motor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2229 | PBD Unit Motor RH Circuit | The multiplex network door ECU detects a malfunction of the power back door unit assembly set RH motor. | ·
Multiplex network door ECU ·
Power back door unit assembly set RH ·
Wire harness or connector |
Clear the DTCs.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC B2229 is not output | A |
| DTC B2229 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Disconnect the X7 multiplex network door ECU connector.
Disconnect the X25 power back door unit assembly set RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| X7-2 (BD+2) - X25-1 (BD+2) | Always | Below 1 Ω |
| X7-1 (BD-2) - X25-2 (BD-2) | Always | Below 1 Ω |
| X7-2 (BD+2) or X25-1 (BD+2) - Body ground | Always | 10 kΩ or higher |
| X7-1 (BD-2) or X25-2 (BD-2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the power back door unit assembly set RH with a new or known good one.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR DRIVE UNIT>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC B2229 is not output | A |
| DTC B2229 is output | B |
A
B