Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
48738
2.REMOVE REAR SUSPENSION ARM COVER
89546
3.SEPARATE REAR SPEED SENSOR (for AWD)
Remove the bolt and separate the rear speed sensor from the rear trailing arm assembly.
48780E
4.REMOVE REAR TRAILING ARM ASSEMBLY
Remove the 2 bolts and separate the No. 3 parking brake cable assembly from the rear trailing arm assembly.
| *a | Wooden Block |
| *b | Jack |
Support the rear No. 2 suspension arm assembly using a jack and wooden block.
Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.
When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
Remove the 4 bolts, 2 washers and rear trailing arm assembly.
Slowly lower the rear No. 2 suspension arm assembly.