Refer to "AWD Warning Remains ON".
Click hereDrivetrain>MF1A (TRANSFER / 4WD / AWD)>DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM>AWD Warning Remains ON
Refer to "AWD Warning Remains ON".
Click hereDrivetrain>MF1A (TRANSFER / 4WD / AWD)>DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM>AWD Warning Remains ON
Check the condition of each related circuit connector before troubleshooting.
Check if CAN communication system DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / Four Wheel Drive / Active Test
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| 4WD Warning Light | AWD warning (multi-information display) | Warning ON/OFF | Observe the multi-information display. |
| Tester Display |
|---|
| 4WD Warning Light |
When performing the 4WD Warning Light Active Test, check 4WD Warning Light in the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| 4WD Warning Light | AWD warning (multi-information display) | ON or OFF | ON: Warning on
OFF: Warning off |
- |
| Tester Display |
|---|
| 4WD Warning Light |
| Result | Proceed to |
|---|---|
| Does not change between ON and OFF | A |
| Changes between ON and OFF | B |
A
B
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING