Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › DRIVE BELT › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019663 2GR-FE ENGINE MECHANICAL _0109577 DRIVE BELT A

2GR-FE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL V-RIBBED BELT

a.
A173434C04
0.573,1.052 0.302,0.615 false 1.656,1.01 1.896,0.656 false 2.177,1.146 2.625,1.073 false 2.021,2.229 2.302,2.51 false 1.271,1.76 1.271,2.594 false 0.417,2.406 0.229,2.594 false 0.146,0.438 0.385,0.656 0.24,0.219 10 false *1 1.896,0.458 2.135,0.677 0.24,0.219 10 false *2 2.667,0.969 2.906,1.188 0.24,0.219 10 false *3 0.104,2.625 0.344,2.844 0.24,0.219 10 false *4 1.177,2.625 1.417,2.844 0.24,0.219 10 false *5 2.344,2.521 2.583,2.74 0.24,0.219 10 false *6
*1 Engine Water Pump Assembly
*2 No. 2 Idler Pulley Sub-assembly
*3 Generator Assembly
*4 Crankshaft Pulley
*5 V-ribbed Belt Tensioner Assembly
*6 Compressor Assembly with Pulley


Install the V-ribbed belt.

NOTICE:
·

Put the backside of the V-ribbed belt on the V-ribbed belt tensioner pulley and No. 2 idler pulley sub-assembly.

·

Check that the V-ribbed belt is properly set to each pulley.




b.
A205851

Turn the V-ribbed belt tensioner counterclockwise and remove the 5 mm hexagon wrench.


c.

After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the crankshaft pulley by hand.


Hide 53736 2.INSTALL FRONT FENDER APRON SEAL RH

Hide 53875A 3.INSTALL FRONT FENDER LINER RH

a.

Install the front fender liner RH with the bolt, 4 screws and 4 clips.


Hide 4.INSTALL FRONT WHEEL RH

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)