Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019663 2GR-FE ENGINE MECHANICAL _0109580 FRONT CRANKSHAFT OIL SEAL A

2GR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 13471 2.REMOVE CRANKSHAFT PULLEY

a.
A208600C03
2.125,1.74 2.594,0.781 2.594,0.781 2.323,2.083 false 0.448,3.052 0.302,2.688 false 0.396,0.625 0.396,0.375 0.396,0.375 1.927,0.375 true 0.479,0.615 0.479,0.375 false 2.51,0.573 2.969,0.958 0.458,0.385 10 false SST 0.427,3.073 0.583,3.24 0.156,0.167 10 true *a 1.979,0.302 2.438,0.688 0.458,0.385 10 false SST
*a Hold
V100135

Turn


Using SST, hold the crankshaft pulley in place and loosen the crankshaft pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.

SST
09213-70011  (09213-70020)
09330-00021  


b.
A259943C03
1.083,2.281 0.667,2.448 0.667,2.448 0.667,2.615 false 2.167,0.573 1.521,0.573 false 0.083,1.698 0.26,1.865 0.177,0.167 10 false *a 0.5,2.635 0.802,2.802 0.302,0.167 10 false SST 1.167,0.49 1.469,0.656 0.302,0.167 10 false SST
*a Hold
V100135

Turn


Using SST, remove the crankshaft pulley bolt and crankshaft pulley.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05021)


c.
A205852

Remove the pulley set key from the crankshaft.


Hide 11301C 3.REMOVE TIMING CHAIN CASE OIL SEAL

a.
A141580C03
1.885,1.26 2.385,0.615 false 0.406,1.469 0.625,0.625 false 2.417,0.479 2.594,0.625 0.177,0.146 10 true *a 0.615,0.438 0.792,0.583 0.177,0.146 10 false *b
*a Protective Tape
*b Cut Position


Using a knife, cut off the lip of the timing chain case oil seal.


b.

Using a screwdriver, pry out the timing chain case oil seal.

NOTICE:

After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.


HINT:

Tape the screwdriver tip before use.