30500
1.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)
30500
2.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for AWD)
32101
3.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
Using SST, hold the crankshaft pulley.
Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly and the front drive plate spacer.
11381A
4.REMOVE REAR ENGINE OIL SEAL
| *a | Protective Tape |
| *b | Cut Position |
Using a knife, cut off the lip of the rear engine oil seal.
Using a screwdriver, pry out the rear engine oil seal.
Be careful not to damage the crankshaft.
Tape the screwdriver tip before use.