11301C
1.INSTALL TIMING CHAIN COVER OIL SEAL
w/o Side Lip:
Apply MP grease to the lip of a new timing gear case or timing chain case oil seal.
Keep the lip free from foreign matter.
Do not allow MP grease to contact the dust seal.
| *a | -0.75 to -1.45 mm (-0.0295 to -0.0571 in.) |
| *b | Dust Seal |
| *c | Lip |
Using SST and a plastic-faced hammer, tap in the timing gear case or timing chain case oil seal.
-0.75 to -1.45 mm (-0.0295 to -0.0571 in.) (From the edge of the timing chain cover sub-assembly)
Do not tap in the timing gear case or timing chain case oil seal at an angle.
Wipe off any MP grease from the crankshaft.
w/ Side Lip:
Apply MP grease to the lip of a new timing gear case or timing chain case oil seal.
Keep the lip free from foreign matter.
Do not allow MP grease to contact the dust seal.
Do not allow MP grease to contact the side lip.
| *a | Side Lip |
| *b | Correct |
| *c | Incorrect |
Fit the timing gear case or timing chain case oil seal to SST.
Visually check that the side lip is not caught on SST.
| *a | -0.75 to -1.45 mm (-0.0295 to -0.0571 in.) |
| *b | Side Lip |
| *c | Dust Seal |
| *d | Lip |
Using SST and a plastic-faced hammer, tap in the timing gear case or timing chain case oil seal.
-0.75 to -1.45 mm (-0.0295 to -0.0571 in.) (From the edge of the timing chain cover sub-assembly)
Do not tap in the timing gear case or timing chain case oil seal at an angle.
Wipe off any MP grease from the crankshaft.
13470
2.INSTALL CRANKSHAFT PULLEY
Align the crankshaft pulley key with the key groove of the crankshaft pulley.
| *a | Hold |
| *b | Turn |
Using SST, hold the crankshaft pulley and install the crankshaft pulley bolt.
SST (crankshaft pulley holding tool) fixing bolt part No.: 91551-80650 (2 pcs)
16361A
3.INSTALL V-RIBBED BELT
53736
4.INSTALL FRONT FENDER APRON SEAL RH
53875A
5.INSTALL FRONT FENDER LINER RH
51441
6.INSTALL NO. 1 ENGINE UNDER COVER
7.INSTALL FRONT WHEEL RH