Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2013.12–2016.11
RM3160E _59 Vehicle Exterior _019724 EXTERIOR PANELS / TRIM _0109633 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Move the front bumper assembly into position.


b.
B361070

Temporarily install the front bumper assembly with the 3 clips as shown in the illustration.


c.

w/ Headlight Cleaner System:

i.

Pull back the side of the front bumper assembly and connect the headlight cleaner hose.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.




d.

Pull back the side of the front bumper assembly, connect the 2 connectors and engage the clamp.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.



e.
B361065

Engage the 4 claws.

HINT:

Use the same procedure for the RH side and LH side.



f.

Install the front bumper assembly with the 8 screws.


Hide 75086 2.CONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY LH

a.
B363578

Engage the 2 clips and 4 claws.


b.

Install the clip.


c.
B361059
2.604,1.427 2.896,1.427 true 2.917,1.344 3.146,1.521 0.229,0.177 10 true *1 0.448,1.875 0.76,2.031 0.313,0.156 10 false *a 1.146,1.896 1.458,2.052 0.313,0.156 10 false *b
*1 Pin Hold Clip
*a Correct
*b Incorrect


Install the clip.


d.

Connect the front fender wheel opening moulding sub-assembly LH with the 2 screws.


e.

Install the pin hold clip as shown in the illustration.

NOTICE:

Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.



Hide 75085A 3.CONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 6.ADD WINDSHIELD WASHER FLUID (w/ Headlight Cleaner System)