Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE OUTER REAR VIEW MIRROR WITH COVER
67832
2.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
3.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
75720
4.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
|
Protective Tape |
Apply protective tape around the front door belt moulding assembly.
| *a | Protective Tape |
Disengage the claw (A).
Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws (B) as shown in the illustration.
Disengage the guide and remove the front door belt moulding assembly.