Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR WINDOW FRAME MOULDING
RM3160E _59 Vehicle Exterior _019724 EXTERIOR PANELS / TRIM _0109642 FRONT DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR WINDOW FRAME MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75720 1.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY

Hide 67862 2.DISCONNECT FRONT DOOR WEATHERSTRIP

a.
B365194

Disengage the 3 clips and disconnect the front door weatherstrip.


Hide 75756C 3.REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING

HINT:

When removing the front door rear window frame moulding, heat the vehicle body and front door rear window frame moulding using a heat light.


Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Front Door Rear Window Frame Moulding 20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the vehicle body or moulding excessively.


a.

Using a heat light, heat the front door rear window frame moulding.


b.
B363126
1.385,1.604 1.76,1.177 true 1.417,2.063 1.865,1.552 true 2.052,1.729 2.427,1.302 true 1.219,1.542 1.531,1.698 0.313,0.156 10 false *a 1.24,2.01 1.552,2.167 0.313,0.156 10 false *b 2.458,1.198 2.771,1.354 0.313,0.156 10 false *a
*a Double-sided Tape
*b Caulking Sponge


Using a moulding remover, disengage the clip and guide, and separate the double-sided tape and caulking sponge to remove the front door rear window frame moulding.


Hide 75754A 4.REMOVE FRONT DOOR UPPER WINDOW FRAME MOULDING

a.

Insert a 4.0 mm (0.157 in.) drill bit into a drill.


b.

Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.

B363124
2.156,0.563 2.313,0.76 0.156,0.198 10 false A

Reference Measurement:
Area Measurement Area Measurement
A 5.0 mm (0.197 in.) - -


NOTICE:

Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.



c.

Lightly press the drill against the rivets to drill off the rivet flanges, and remove the 6 rivets.

NOTICE:
·

Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

·

Prying the rivets with the drill may damage the rivet installation holes or drill bit.

·

Be careful of the drilled rivets, as they may be hot.




d.

Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled areas.


e.

Disengage the 2 guides and clip to remove the front door upper window frame moulding from the door frame.