The engine control unit communicates with the TCM using the Controller Area Network (CAN).
If there is a problem in this communication, the TCM stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | Following conditions are met for 1.25 seconds (1 trip detection logic):
·
Ignition switch ON ·
Battery voltage is 10.5 V or more ·
No communication between the engine control ECU (ECM) and TCM |
·
Harness and connector ·
ECM ·
TCM |
Comes on | DTC stored |
Refer to inspection procedure for CAN communication system.
If the CAN communication malfunctions, the TCM cannot receive the current data from the ECM. In this case, the freeze frame data output from the TCM has not been updated, so the data will not be useful for the inspection. However, reading the Data List as the first step in troubleshooting is effective to find malfunctions.
The malfunction area can be checked using the Bus Check function on the GTS.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| *a | Front view of wire harness connector
(to TCM) |
Disconnect the TCM connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C3-18 (+B) - C3-8 (E1) | Ignition switch ON | 9 to 14 V |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C3-8 (E1) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the TCM connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C3-6 (CAN+) - C1-31 (CAN+) | Always | Below 1 Ω |
| C3-7 (CAN-) - C1-1 (CAN-) | Always | Below 1 Ω |
| C3-6 (CAN+) or C1-31 (CAN+) - Body ground and other terminals | Always | 10 kΩ or higher |
| C3-7 (CAN-) or C1-1 (CAN-) - Body ground and other terminals | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Clear the DTCs.
Replace the TCM.
Replace the TCM with a TCM from a normally functioning vehicle of the same model.
Start the engine.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC U0100 is output | A |
| DTCs are not output | B |
A
B