Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0109815 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

·

The ECM turns on the cruise control indicator by sending indicator output demand signals to the combination meter assembly via CAN communication.

·

The cruise control indicator illuminates (green) when the cruise control system is turned on using the cruise control main switch (ON-OFF button). If a malfunction is detected, the cruise control indicator goes out and a warning message is displayed.

·

The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Check the cruise control indicator by performing the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Indicat. Lamp Cruise Cruise control indicator (illuminated in green) ON / OFF for Multi-information Display (Monochrome Type)
Meter Display 1 Multi-information display OFF / All for Multi-information Display (Color Type)
Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. Lamp Cruise
50004 122 46
Body Electrical > Combination Meter > Active Test
Tester Display
Meter Display 1
50004 122 7
OK:
for Multi-information Display (Monochrome Type):

The cruise control indicator light comes on or goes out.

for Multi-information Display (Color Type):

The multi-information display turns on or off.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE COMBINATION METER ASSEMBLY