1.INSTALL PIPING CLAMP
for Low Pressure:
Remove the vinyl tape from the suction hose sub-assembly and No. 1 air conditioning accessory assembly.
Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces of the suction hose sub-assembly.
ND-OIL 8 or equivalent
Install the 2 O-rings to the suction hose sub-assembly.
Install the suction hose sub-assembly to the No. 1 air conditioning accessory assembly.
| *a | Correct |
| *b | Incorrect |
| *c | No Gap |
| *d | Gap |
Install the piping clamp to the No. 1 air conditioning accessory assembly.
Make sure that the piping clamp is engaged securely with no gap.
for High Pressure:
Remove the vinyl tape from the air conditioner tube and accessory assembly and No. 1 air conditioning accessory assembly.
Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces of the air conditioner tube and accessory assembly.
ND-OIL 8 or equivalent
Install the 2 O-rings to the air conditioner tube and accessory assembly.
Install the air conditioner tube and accessory assembly to the No. 1 air conditioning accessory assembly.
| *a | Correct |
| *b | Incorrect |
| *c | No Gap |
| *d | Gap |
Install the piping clamp to the No. 1 air conditioning accessory assembly.
Make sure that the piping clamp is engaged securely with no gap.
55701J
2.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
55701J
3.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
4.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
5.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
6.WARM UP ENGINE
7.INSPECT FOR REFRIGERANT LEAK