Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR
RM3160E _58 Vehicle Interior _019714 HEATING / AIR CONDITIONING _0109969 FRONT EVAPORATOR TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 88625 1.INSTALL NO. 1 COOLER THERMISTOR

a.
E287845
1.917,1 2.167,1.406 false 2.563,1.427 2.875,1.167 false 2.198,3.74 2.052,3.354 false 2.573,3.573 2.24,3.354 false 1.51,2.365 1.667,2.563 0.156,0.198 10 false A 1.5,2.833 1.656,3.031 0.156,0.198 10 false B 1.125,3.625 1.281,3.823 0.156,0.198 10 false C 2.323,0.594 2.479,0.792 0.156,0.198 10 false X 1.802,0.854 1.958,1.052 0.156,0.198 10 false a 2.906,1.031 3.063,1.229 0.156,0.198 10 false b 2.156,3.75 2.354,3.948 0.198,0.198 10 true *a 2.594,3.49 2.802,3.688 0.208,0.198 10 true *b
*a Fixed Part
*b Sensor Part


Install the No. 1 cooler thermistor as shown in the illustration.

Installation Position:
Part Length
A 34.3 mm (1.35 in.)
B 20.9 mm (0.823 in.)
C 50.0 mm (1.97 in.)


NOTICE:
·

Be sure to insert the No. 1 cooler thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

·

When reusing the No. 1 cooler evaporator sub-assembly, insert the No. 1 cooler thermistor one row next to the one that has been used previously (X in the illustration).

·

After inserting the No. 1 cooler thermistor, do not apply excessive force to the wire.

·

Directly insert the No. 1 cooler thermistor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".




Hide 88501 2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

Hide 3.INSTALL BLOWER ASSEMBLY WITH COOLER EVAPORATOR SUB-ASSEMBLY