Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0110870 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1572  Improper Aiming of Radar Sensor Beam Axis  


DESCRIPTION

This DTC is stored when the scanning angle of the millimeter wave radar sensor assembly is incorrect. This DTC is also stored when the millimeter wave radar sensor beam axis is determined to be in an incorrect position.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1572 Improper Aiming of Radar Sensor Beam Axis The ECM detects that the millimeter wave radar sensor assembly beam axis is in an incorrect position (0.15 seconds or more) while the dynamic radar cruise control is operating. Millimeter wave radar sensor assembly

PROCEDURE

1.ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY
a.

Adjust the millimeter wave radar sensor assembly.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTCS (DTC P1572)
2.CHECK FOR DTCS (DTC P1572)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which cruise control operation is possible.


ii.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Powertrain > Radar Cruise > Trouble Codes
50001 239

Result:
Result Proceed to
DTCs are not output A
DTC P1572 is output B


g.

Turn the engine switch off.



A

END

B

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY