Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2013.12–2016.11
RM3160E _58 Vehicle Interior _019711 PRE-CRASH SAFETY _0110871 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1A46  Yaw Rate Sensor  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives vehicle stability control system signals from the airbag sensor assembly (yaw rate sensor) and sends the signals to the driving support ECU assembly and network gateway ECU. If the skid control ECU (brake actuator assembly) detects that the airbag sensor assembly (yaw rate sensor) is malfunctioning, the skid control ECU (brake actuator assembly) sends a malfunction signal to the driving support ECU assembly, and the driving support ECU assembly stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A46 Yaw Rate Sensor While the vehicle speed is 5 km/h (3 mph) or more, an airbag sensor assembly (yaw rate sensor) malfunction signal is received from the skid control ECU (brake actuator assembly) for 1 second or more.
·

Vehicle stability control system

·

Skid control ECU (brake actuator assembly)

·

Airbag sensor assembly (yaw rate sensor)

·

Driving support ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.


PROCEDURE

1.CHECK FOR DTC (ABS/VSC/TRC)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.


e.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
Vehicle stability control system DTCs are not output A
Vehicle stability control system DTCs are output B


f.

Turn the engine switch off.



A

2.REPLACE BRAKE ACTUATOR ASSEMBLY

B

2.REPLACE BRAKE ACTUATOR ASSEMBLY
a.

Replace the brake actuator assembly with a new one.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC (PRE-CRASH 2)
3.CHECK FOR DTC (PRE-CRASH 2)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



e.

Enter the following menus: Body Electrical / Pre-Crash 2 / Trouble Codes.


f.

Check for DTCs.

Body Electrical > Pre-Crash 2 > Trouble Codes
50001 220

Result:
Result Proceed to
DTC C1A46 is not output A
DTC C1A46 is output B


g.

Turn the engine switch off.



A

END (BRAKE ACTUATOR ASSEMBLY WAS DEFECTIVE)

B