Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR AIRBAG SENSOR › from 2015.11
RM3160E _58 Vehicle Interior _019710 SUPPLEMENTAL RESTRAINT SYSTEMS _0109995 REAR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE REAR NO. 2 SEAT ASSEMBLY

Hide 58387B 4.REMOVE REAR FLOOR FINISH PLATE

Hide 72138M 5.REMOVE REAR OUTER SEAT TRACK BRACKET COVER

Hide 67918A 6.REMOVE REAR DOOR SCUFF PLATE

Hide 7.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

HINT:

Disconnect the rear door opening trim weatherstrip to the extent that allows the removal of the deck trim side panel assembly.


Hide 64713F 8.REMOVE FRONT DECK SIDE TRIM COVER

Hide 73370C 9.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY

Hide 64715E 10.REMOVE NO. 2 DECK SIDE TRIM COVER (for LH Side)

Hide 64714H 11.REMOVE NO. 1 DECK SIDE TRIM COVER (for RH Side)

Hide 73570 12.DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY

Hide 62627D 13.REMOVE SIDE TRIM COVER RH (w/o Rear Automatic Air Conditioning System)

Hide 88625T 14.REMOVE COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR (w/ Rear Automatic Air Conditioning System)

Hide 81330 15.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for RH Side)

Hide 64974 16.REMOVE DECK TRIM POCKET COVER

Hide 64725F 17.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Hide 64740C 19.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

Hide 64730B 20.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)

Hide 89834 21.REMOVE REAR AIRBAG SENSOR

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Disconnect the connector from the rear airbag sensor.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


i.

Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

C195226C18
3.927,1.313 3.927,2.146 false 1.385,1.313 1.385,2.146 true 1.135,0.99 1.135,0.531 1.135,0.531 1.052,0.531 true 3.646,1 3.646,0.542 3.646,0.542 3.563,0.542 true 0.948,1.156 0.417,0.729 true 3.469,1.146 2.938,0.74 true 0.854,0.438 1.042,0.615 0.188,0.177 10 false *a 3.375,0.469 3.563,0.646 0.188,0.177 10 false *a 1.313,2.208 1.5,2.385 0.188,0.177 10 false *b 0.969,1.708 1.156,1.885 0.188,0.177 10 false *c 3.531,1.729 3.719,1.906 0.188,0.177 10 false *c 3.823,2.177 4.01,2.354 0.188,0.177 10 false *b 1.427,0.625 1.615,0.802 0.188,0.177 10 false *d 3.875,0.646 4.063,0.823 0.188,0.177 10 false *d 0.281,0.615 0.448,0.823 0.167,0.208 10 false A 2.792,0.625 3.042,0.813 0.25,0.188 10 false A
*a White Housing Lock *b Yellow CPA
*c Slide *d Push



ii.

Push down the white housing lock again and disconnect the connector.

NOTICE:

Do not push down the part (A) shown in the illustration when disconnecting the connector.




d.
B351407

Remove the nut and rear airbag sensor from the vehicle body.

NOTICE:

Loosen the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.



e.

After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

B296256C01
5.01,0.51 5.302,0.781 0.292,0.271 10 *b 1.792,0.51 2.083,0.802 0.292,0.292 10 *a
*a Correct *b Incorrect