Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › from 2016.11
RM3160E _56 Audio / Visual / Telematics _019700 AUDIO / VIDEO _0096790 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Reverse Signal Circuit  


DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the BACK UP LP relay.

WIRING DIAGRAM

E265477E56
5.208,1.99 5.667,2.188 0.458,0.198 10 false F71 5.208,2.146 6.396,2.646 1.188,0.5 10 false Radio and Display Receiver Assembly 5.396,1.104 5.854,1.302 0.458,0.198 10 false REV 5.229,0.99 5.688,1.188 0.458,0.198 10 false 2 1.031,1.094 3.115,1.448 2.083,0.354 10 false from BACK UP LP Relay

PROCEDURE

1.CHECK BACK-UP LIGHT
a.

Move the shift lever to R and check if the back-up lights come on.

OK:

The back-up lights come on.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

NG

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
a.

Disconnect the F71 radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F71-2 (REV) - Body ground Ignition switch ON
Shift lever in R
11 to 14 V
F71-2 (REV) - Body ground Ignition switch ON
Shift lever in any position other than R
Below 1 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR