The telematics transceiver sends a mute signal to the radio and display receiver assembly.
The radio and display receiver assembly controls the volume according to the mute signal from the telematics transceiver.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
| *a | Component with harness connected
(Telematics Transceiver) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F140-17 (MUTE) - Body ground | Engine switch on (ACC)
Audio system playing → Emergency call mode |
2.0 V or higher
→ Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F69 radio and display receiver assembly connector.
Disconnect the F140 telematics transceiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F69-8 (TMUT) - F140-17 (MUTE) | Always | Below 1 Ω |
| F69-8 (TMUT) or F140-17 (MUTE) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F140 telematics transceiver connector.
| *a | Front view of wire harness connector
(Telematics Transceiver) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F140-17 (MUTE) - Body ground | Engine switch on (ACC) | 2.0 V or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG