Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2016.11
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0109815 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0503  Vehicle Speed Sensor "A" Intermittent / Erratic / High  


DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while the cruise control is controlling vehicle speed, the ECM determines that there is a momentary interruption or noise, and stores a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0503 Vehicle Speed Sensor "A" Intermittent / Erratic / High A momentary interruption or noise is detected when a rapid change in the vehicle speed occurs while the cruise control system is controlling vehicle speed.
·

Vehicle speed sensor

·

Vehicle speed sensor signal circuit

·

Combination meter assembly

·

ECM



CAUTION / NOTICE / HINT

This DTC may be output by the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.

PROCEDURE

1.CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.


e.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.REPLACE COMBINATION METER ASSEMBLY

B

2.REPLACE COMBINATION METER ASSEMBLY
a.

Replace the combination meter assembly.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
3.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 237

e.

Perform the following to make sure that the DTC detection condition is met.

HINT:

If the following condition is not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which cruise control operation is possible.


ii.

Turn the cruise control system on using the cruise control main switch (ON-OFF button).


iii.

Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.



f.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 237

Result:
Result Proceed to
DTCs are not output A
DTC P0503 is output B



A

END (COMBINATION METER ASSEMBLY WAS DEFECTIVE)

B