DTC C1A52 is stored when the ECM cannot recognize the driving support ECU assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A52 | Driving Support ECU Communication Abnormal | Approximately 17 seconds after the engine switch is turned on (IG), the ECM cannot recognize the driving support ECU assembly for approximately 1.3 seconds or more. | ·
ECM ·
Driving support ECU assembly |
When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.
Clear the DTCs.
Perform the following to make sure that the DTC detection conditions are met.
If the following conditions are not met, the system cannot detect the malfunction.
Turn the engine switch on (IG).
Wait for 20 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1A52 is not output | A |
| DTC C1A52 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Replace the ECM.
Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Perform the following to make sure that the DTC detection conditions are met.
If the following conditions are not met, the system cannot detect the malfunction.
Turn the engine switch on (IG).
Wait for 20 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1A52 is not output | A |
| DTC C1A52 is output | B |
A
B