The skid control ECU (brake actuator assembly) sends signals such as cruise control cancel signals and brake demand response signals to the ECM when the dynamic radar cruise control system is operating.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P1630 | Communication Error from VSC to ECM | While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, communication data from the skid control ECU (brake actuator assembly) is logically inconsistent for approximately 0.5 seconds or more. | ·
CAN communication circuit ·
Skid control ECU (brake actuator assembly) ·
ECM |
First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Using the GTS, check if the CAN communication system is functioning normally.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | OK |
| CAN communication system DTCs are output | NG |
OK
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the DTCs.
Perform the following to make sure that the DTC detection conditions are met.
If the following conditions are not met, the malfunction cannot be detected.
Turn the engine switch on (IG).
Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
Drive the vehicle at 36 km/h (22 mph) or more for 0.5 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC P1630 is not output | A |
| DTC P1630 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Replace the brake actuator assembly.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Perform the following to make sure that the DTC detection conditions are met.
If the following conditions are not met, the malfunction cannot be detected.
Turn the engine switch on (IG).
Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
Drive the vehicle at 36 km/h (22 mph) or more for 0.5 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC P1630 is not output | A |
| DTC P1630 is output | B |
A
B