This DTC is stored when the main body ECU (multiplex network body ECU) detects a malfunction in the automatic high beam system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B124B | Automatic High Beam System | Malfunction in automatic high beam system | ·
Forward recognition camera system ·
Dynamic radar cruise control system ·
Lane departure alert system ·
Pre-collision system ·
SFI system ·
Vehicle stability control system ·
CAN communication system ·
Forward recognition camera ·
Main body ECU (multiplex network body ECU) |
The automatic high beam system uses the CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the automatic high beam system after confirming that the communication systems are functioning properly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.*
*: w/ Smart Entry and Start System
Speed sensor
Yaw rate sensor
Steering sensor
CAN communication system
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: System Select / Health Check.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B124B is output | A |
| DTC B124B and other DTCs are output | B |
A
B
Check if a dynamic radar cruise control system, lane departure alert system or pre-collision system warning message is displayed on the multi-information display.
Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DIAGNOSIS SYSTEM
No dynamic radar cruise control system, lane departure alert system and pre-collision system warning messages are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>PROBLEM SYMPTOMS TABLE