| *a | Centering Bolt |
| *b | Standard Bolt |
Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.
Specified torque for standard bolts is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
53301
1.INSPECT HOOD SUB-ASSEMBLY
53301
2.ADJUST HOOD SUB-ASSEMBLY
Horizontally and vertically adjust the hood.
Loosen the hinge bolts of the hood.
Adjust the clearance between the hood and front fender by moving the hood.
Tighten the hinge bolts after adjustment.
Adjust the height of the front end of the hood using the hood bumper cushions.
Adjust the hood bumper cushions so that the heights of the hood and fender are aligned.
Raise or lower the front end of the hood by turning the hood bumper cushions.
Remove radiator grille.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>RADIATOR GRILLE>REMOVAL
Adjust the hood lock.
| *a | Protective Tape |
Using a screwdriver, remove the hood lock nut cap.
Tape the screwdriver tip before use.
| *1 | Hood Lock Bolt |
Loosen the 2 bolts and hood lock bolt.
Adjust the hood lock and tighten the 2 bolts and hood lock bolt.
Check that the striker can engage with the hood lock smoothly.
Install a new hood lock nut cap.
Install radiator grille.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>RADIATOR GRILLE>INSTALLATION