Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 6 Sensor Type) › from 2016.11
RM3160E _56 Audio / Visual / Telematics _019702 PARK ASSIST / MONITORING _0297894 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 6 Sensor Type) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 6 Sensor Type)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E289077E02
0.448,0.698 1.802,1.156 1.354,0.458 10 false from IG1 NO. 3 Relay 2.646,0.854 3.323,1.417 0.677,0.563 10 false IG1 NO. 3 5.24,0.583 5.552,0.781 0.313,0.198 10 false 12 5.49,0.698 5.802,0.896 0.313,0.198 10 false IG 5.25,1.354 5.563,1.552 0.313,0.198 10 false 27 5.479,1.469 5.635,1.667 0.156,0.198 10 false E 5.063,2.115 6.604,2.604 1.542,0.49 10 false Clearance Warning ECU Assembly 5.073,1.958 5.531,2.156 0.458,0.198 10 false F87

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY)
a.

Disconnect the F87 clearance warning ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F87-12 (IG) - Body ground Ignition switch ON 11 to 14 V
F87-12 (IG) - Body ground Ignition switch off Below 1 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F87-27 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR