Home › Engine / Hybrid System › 2GR-FKS (COOLING) › WATER PUMP › from 2016.11
RM3160E _51 Engine / Hybrid System _060161 2GR-FKS COOLING _0297902 WATER PUMP A

2GR-FKS COOLING  WATER PUMP  REMOVAL  


PROCEDURE

Hide 16031 1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16604 3.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

a.
A394888

Remove the bolt and No. 2 idler pulley sub-assembly.


Hide 16173 4.REMOVE WATER PUMP PULLEY

a.
A478643C02
0.917,2.302 1.063,2.302 1.063,2.302 1.198,1.625 true 2.417,2.667 2.25,2.667 2.25,2.667 2.031,1.885 true 1.708,0.917 1.99,0.573 1.99,0.573 2.146,0.573 true 2.427,2.583 2.677,2.771 0.25,0.188 10 true *a 0.729,2.229 0.917,2.406 0.188,0.177 10 true *b 2.156,0.5 2.385,0.656 0.229,0.156 10 true *c
*a Protective Tape
*b Hold
*c Turn


Using a screwdriver or equivalent with its tip wrapped in protective tape, hold the water pump pulley.


b.

Remove the 4 bolts and water pump pulley.

HINT:

There is not enough clearance to completely remove the water pump pulley from the water pump shaft. Remove the water pump pulley together with the engine water pump assembly.



Hide 16100 5.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A394890

Remove the 15 bolts, engine water pump assembly, water pump pulley and water pump gasket.