1.DRAIN ENGINE COOLANT
11209
2.REMOVE V-BANK COVER SUB-ASSEMBLY
3.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)
55701J
4.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
47220D
5.SEPARATE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY (for RHD)
47233
6.REMOVE RESERVOIR BRACKET (for RHD)
12327A
7.REMOVE NO. 2 ENGINE MOUNTING STAY RH
12313
8.REMOVE ENGINE MOVING CONTROL ROD BRACKET
82121
9.DISCONNECT ENGINE WIRE
Disconnect the water inlet with thermostat sub-assembly connector.
Remove the bolt to disconnect the engine wire.
12315
10.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH
Loosen the 7 bolts.
There is not enough clearance to completely remove some of the 7 bolts from the front No. 1 engine mounting bracket LH.
Remove the front No. 1 engine mounting bracket LH together with the bolts.
16572D
11.DISCONNECT NO. 2 RADIATOR HOSE
16261
12.DISCONNECT WATER BY-PASS HOSE
Slide the clip and disconnect the water by-pass hose.
16031
13.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Remove the 2 bolts, 2 nuts and water inlet with thermostat sub-assembly.
Remove the gasket from the water inlet with thermostat sub-assembly.