Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT LEVER › from 2016.11
RM3160E _52 Drivetrain _060164 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0298236 SHIFT LEVER A

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  REMOVAL  


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 33554 2.REMOVE SHIFT LEVER CAP

a.
C298997

Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the shift lever cap from the shift position indicator.

NOTICE:

Be careful not to damage the shift lever cap and shift position indicator.



Hide 58843 4.REMOVE SHIFTING HOLE BEZEL

a.
C298998

Disconnect the shift position indicator connector.


b.
C298999

Remove the 5 screws and shifting hole bezel from the upper console panel sub-assembly.


Hide 35978 5.REMOVE SHIFT POSITION INDICATOR

a.
C299000

Disengage the claw and 2 guides and remove the shift position indicator from the shifting hole bezel.


Hide 55446E 6.REMOVE NO. 2 SWITCH HOLE BASE

Hide 58817A 7.REMOVE FRONT NO. 2 CONSOLE BOX INSERT

Hide 58996A 9.REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET

a.
C299001

Disengage the clamp from the No. 2 console box mounting bracket.


b.
C299002

Remove the 2 screws and No. 2 console box mounting bracket from the transmission floor shift assembly.


Hide 33550 10.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

a.

Move the shift lever to N.


b.
C299003C01
1.146,0.625 1.385,0.844 0.24,0.219 10 true *a 2.729,1.146 3,1.354 0.271,0.208 10 true *b
*a Transmission Control Switch Connector
*b Shift Lock Control ECU Connector


Disconnect the transmission control switch connector.


c.

Disconnect the shift lock control ECU connector.


d.
C299004

Separate the transmission control cable assembly from the transmission floor shift assembly.


e.
C299005C01
2.115,2.052 2.385,2.26 0.271,0.208 10 true *a
*a Counterclockwise


Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, separate the transmission control cable assembly from the transmission floor shift assembly.


f.
C299006

Remove the 4 nuts and transmission floor shift assembly from the shift lever support.