Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR(for Front Side) › from 2016.11
RM3160E _56 Audio / Visual / Telematics _019702 PARK ASSIST / MONITORING _0298528 ULTRASONIC SENSOR(for Front Side) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Front Side)  INSTALLATION  


PROCEDURE

Hide 89347B 1.INSTALL FRONT CORNER ULTRASONIC SENSOR RETAINER

HINT:
·

Perform this procedure only when replacement of the front corner ultrasonic sensor retainer is necessary.

·

If a front corner ultrasonic sensor retainer has been removed, replace it with a new one. Install the No. 1 ultrasonic sensor with a new front corner ultrasonic sensor retainer as a set to the front bumper assembly.

·

Use the same procedure for all front corner ultrasonic sensor retainers.



a.
E351850

Engage the 2 claws to install a new front corner ultrasonic sensor retainer to the No. 1 ultrasonic sensor.


b.

Clean the front bumper assembly surface.

i.

Remove any remaining double-sided tape from the front bumper assembly.


ii.

Wipe off any tape adhesive residue with cleaner.



c.
E335575C03
1.719,1.125 1.938,1.292 0.219,0.167 10 true *a
*a 18 mm (0.709 in.)


Cover the sensor installation hole with a 18 mm (0.709 in.) circular piece of tape.


d.
E351677C01
0,0 0,0 false
V100144

Primer


Using a brush or felt, apply primer or equivalent to the front corner ultrasonic sensor retainer installation area.

NOTICE:
·

Use a clean brush or felt.

·

Do not touch the front bumper assembly until the primer has dried.




e.

Confirm that the primer has completely dried by touching the front bumper assembly. Then remove the tape.


f.

Peel off the release paper from the new front corner ultrasonic sensor retainer.


g.
E357406C01
1.271,1.708 1.271,1.427 false 0.438,1.021 0.677,1.021 true 1.208,1.719 1.417,1.906 0.208,0.188 10 true *a 0.24,0.927 0.448,1.115 0.208,0.188 10 true *b
*a Scribed Line
*b Protrusion of the mark


Align the front corner ultrasonic sensor retainer with No. 1 ultrasonic sensor with the mark on the front bumper assembly and install it as shown in the illustration.

NOTICE:
·

Ensure that the sensor tip is correctly inserted into the sensor installation hole of the front bumper assembly.

·

Ensure that the front corner ultrasonic sensor retainer is within the scribed line.

·

The double-sided tape of a front corner ultrasonic sensor retainer will deteriorate if it is detached. Make sure to replace the front corner ultrasonic sensor retainer with a new one when reattachment is necessary.



HINT:
·

Align the connector with the protrusion of the mark when connecting it.

·

Press the front corner ultrasonic sensor retainer with a force of 30 N (3.0 kgf) for 3 seconds and install the front corner ultrasonic sensor retainer firmly so that there is no clearance between the front corner ultrasonic sensor retainer and front bumper assembly.




Hide 89341K 2.INSTALL NO. 1 ULTRASONIC SENSOR

HINT:

Use the same procedure for all No. 1 ultrasonic sensors.


a.

When replacing only the No. 1 ultrasonic sensor:

i.

Engage the 2 claws to install the No. 1 ultrasonic sensor.



b.

Connect the connector.


Hide 3.INSTALL FRONT BUMPER ASSEMBLY