Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Navigation Receiver Type) › from 2016.11
RM3160E _56 Audio / Visual / Telematics _019701 NAVIGATION / MULTI INFO DISPLAY _0104171 NAVIGATION SYSTEM(for Navigation Receiver Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Navigation Receiver Type)  AVC-LAN Circuit  


DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN communicates via AVC-LAN communication.

If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible.

WIRING DIAGRAM

E354630E05
0.906,3.396 2.958,3.604 2.052,0.208 10 false : AVC-LAN Communication Line 4.833,2.01 5.208,2.208 0.375,0.198 10 false F118 4.823,2.427 5.198,2.625 0.375,0.198 10 false F118 4.823,0.729 5.198,0.927 0.375,0.198 10 false F117 4.813,0.333 5.188,0.531 0.375,0.198 10 false F117 4.771,2.823 6.656,3.031 1.885,0.208 10 false Navigation Receiver Assembly 1.542,2.958 3.479,3.167 1.938,0.208 10 false Television Display Assembly*2 1.552,2.802 1.792,2.979 0.24,0.177 10 false S8 2.302,1.99 2.833,2.188 0.531,0.198 10 false TX1+ 2.354,2.417 2.729,2.594 0.375,0.177 10 false TX1- 4.948,1.823 5.063,2 0.115,0.177 10 false 9 2.719,1.885 2.854,2.042 0.135,0.156 10 false 3 5.24,2.021 5.552,2.198 0.313,0.177 10 false TX+ 5.24,2.438 5.531,2.615 0.292,0.177 10 false TX- 4.906,2.229 5.083,2.417 0.177,0.188 10 false 10 2.729,2.281 2.865,2.438 0.135,0.156 10 false 4 1.51,1.271 2.938,1.469 1.427,0.198 10 false Parking Assist ECU*1 1.51,1.115 1.938,1.313 0.427,0.198 10 false F131 5.229,0.323 5.625,0.51 0.396,0.188 10 false TX3+ 5.24,0.729 5.583,0.906 0.344,0.177 10 false TX3- 4.958,0.135 5.073,0.313 0.115,0.177 10 false 7 4.979,0.531 5.125,0.708 0.146,0.177 10 false 8 2.396,0.323 2.708,0.5 0.313,0.177 10 false TX+ 2.406,0.719 2.698,0.896 0.292,0.177 10 false TX- 2.708,0.188 2.906,0.365 0.198,0.177 10 false 10 2.719,0.583 2.917,0.76 0.198,0.177 10 false 9 3.885,3.177 6.813,3.396 2.927,0.219 10 false *1: w/ Panoramic View Monitor System 3.896,3.458 6.365,3.677 2.469,0.219 10 false *2: w/ Rear Seat Entertainment System

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for Navigation Receiver Type)>PRECAUTION



HINT:

The navigation receiver assembly is the master unit.


PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY

b.
E286972C07
1.417,0.917 1.833,1.167 0.417,0.25 1.865,2.229 1.635,1.771 false 1.302,2.219 1.49,1.76 false 0.135,0.125 0.635,0.396 0.5,0.271 10 false *a (*A) 1.833,2.271 2.448,2.469 0.615,0.198 10 false TX3+ 1.135,2.25 1.75,2.448 0.615,0.198 10 false TX3- 1.469,0.958 1.969,1.229 0.5,0.271 10 false F117
*A w/ Panoramic View Monitor System
*a Component without harness connected
(Navigation Receiver Assembly)


E231034C05
1.49,0.271 1.896,0.542 0.406,0.271 1.479,1.594 1.625,1.25 false 1.885,1.583 1.76,1.25 false 0.094,0.094 0.635,0.344 0.542,0.25 10 false *a (*A) 1.323,1.625 1.781,1.823 0.458,0.198 10 false TX- 1.865,1.625 2.323,1.823 0.458,0.198 10 false TX+ 1.542,0.323 2,0.521 0.458,0.198 10 false F118
*A w/ Rear Seat Entertainment System
*a Component without harness connected
(Navigation Receiver Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F117-7 (TX3+) - F117-8 (TX3-)*1 Always 60 to 80 Ω
F118-9 (TX+) - F118-10 (TX-)*2 Always 60 to 80 Ω


*1: w/ Panoramic View Monitor System

*2: w/ Rear Seat Entertainment System



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)

NG

2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)
a.

Disconnect the F117*1 and F118*2 navigation receiver assembly connectors.

*1: w/ Panoramic View Monitor System

*2: w/ Rear Seat Entertainment System



b.

Disconnect the F131 parking assist ECU connector (w/ Panoramic View Monitor System).


c.

Disconnect the S8 television display assembly connector (w/ Rear Seat Entertainment System).


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (w/ Panoramic View Monitor System):
Tester Connection Condition Specified Condition
F117-7 (TX3+) - F131-10 (TX+) Always Below 1 Ω
F117-8 (TX3-) - F131-9 (TX-) Always Below 1 Ω
F117-7 (TX3+) or F131-10 (TX+) - Body ground Always 10 kΩ or higher
F117-8 (TX3-) or F131-9 (TX-) - Body ground Always 10 kΩ or higher


Standard Resistance (w/ Rear Seat Entertainment System):
Tester Connection Condition Specified Condition
F118-9 (TX+) - S8-3 (TX1+) Always Below 1 Ω
F118-10 (TX-) - S8-4 (TX1-) Always Below 1 Ω
F118-9 (TX+) or S8-3 (TX1+) - Body ground Always 10 kΩ or higher
F118-10 (TX-) or S8-4 (TX1-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT MALFUNCTIONING PARTS

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT MALFUNCTIONING PARTS
a.

Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

HINT:
·

Check all slave units.

·

If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.



OK:

Master unit returns to normal operation.



Result:
Proceed to
OK
NG



OK

REPLACE MALFUNCTIONING PARTS

NG