Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
73200A
1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Engage the guide and temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.
Fully tighten the bolt (A) first, then the bolt (B) to install the front shoulder belt anchor adjuster assembly.
73220
2.INSPECT FRONT SEAT OUTER BELT ASSEMBLY
73220
3.INSTALL FRONT SEAT OUTER BELT ASSEMBLY
Temporarily install the front seat outer belt assembly with the 2 bolts.
Fully tighten the bolt (A) first, then the bolt (B).
| *a | Locking Button |
| *b | Lock |
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Securely lock the locking button.
Connect the shoulder anchor of the front seat outer belt assembly with the nut.
Check that the ELR locks.
The check should be performed with the front seat outer belt assembly installed.
With the belt assembly installed, check that the belt locks when it is pulled out quickly.
62412
4.INSTALL CENTER PILLAR GARNISH
73220
5.CONNECT FRONT SEAT OUTER BELT ASSEMBLY
Connect the floor anchor of the front seat outer belt assembly with the bolt.
62414A
6.INSTALL LOWER CENTER PILLAR GARNISH
7.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
67918A
8.INSTALL REAR DOOR SCUFF PLATE
72138M
9.INSTALL REAR OUTER SEAT TRACK BRACKET COVER
10.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
67914
11.INSTALL FRONT DOOR SCUFF PLATE
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
13.INSPECT SRS WARNING LIGHT