The occupant detection sensor (separate type front seat cushion pad) detects if the passenger seat is occupied and sends signals to the combination meter assembly. The front seat inner belt assembly (front passenger seat) detects the passenger seat belt condition and sends signals to the combination meter assembly. After receiving the signals from the occupant detection sensor (separate type front seat cushion pad) and front seat inner belt assembly (front passenger seat), the seat belt warning light on the combination meter assembly will blink or go off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| P-Seatbelt Buckle SW | Front passenger seat belt buckle switch | ON or OFF | OFF: Front passenger seat belt fastened
ON: Front passenger seat belt unfastened |
The front passenger seat is occupied |
| Tester Display |
|---|
| P-Seatbelt Buckle SW |
The GTS display changes correctly in response to the front passenger seat belt condition.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the occupant detection sensor (separate type front seat cushion pad).
Click hereVehicle Interior>SEAT BELT>OCCUPANT DETECTION SENSOR>REMOVAL
Inspect the occupant detection sensor (separate type front seat cushion pad).
Click hereVehicle Interior>SEAT BELT>OCCUPANT DETECTION SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front seat inner belt assembly (front passenger seat).
for Manual Seat: Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY(for Power Seat)>REMOVAL
Inspect the front seat inner belt assembly (front passenger seat).
for Manual Seat: Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat)>INSPECTION
for Power Seat: Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY(for Power Seat)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for Manual Seat: Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY(for Power Seat)>REMOVAL
Disconnect the F126 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F126-15 (PBLT) - L6-4(+) | Always | Below 1 Ω |
| F126-15 (PBLT) or L6-4(+) - Body ground | Always | 10 kΩ or higher |
| L6-3(E) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F126-15 (PBLT) - M5-3(+) | Always | Below 1 Ω |
| F126-15 (PBLT) or M5-3(+) - Body ground | Always | 10 kΩ or higher |
| M5-2(E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG