Home › Engine / Hybrid System › 2GR-FKS (ENGINE MECHANICAL) › DRIVE BELT › from 2016.11
RM3160E _51 Engine / Hybrid System _060157 2GR-FKS ENGINE MECHANICAL _0298894 DRIVE BELT A

2GR-FKS ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL V-RIBBED BELT

a.
A266139C01
1.052,0.552 1.313,0.74 0.26,0.188 10 *1 1.948,0.427 2.177,0.688 0.229,0.26 10 *2 2.438,0.5 2.625,0.729 0.188,0.229 10 *3 0.917,1.375 1.219,1.604 0.302,0.229 10 *4 1.646,0.927 1.885,1.115 0.24,0.188 10 *5 2.115,1.365 2.344,1.594 0.229,0.229 10 *6
*1 Engine Water Pump Assembly
*2 No. 2 Idler Pulley Sub-assembly
*3 Generator Assembly
*4 Crankshaft Pulley
*5 V-ribbed Belt Tensioner Assembly
*6 Compressor Assembly with Pulley


Install the V-ribbed belt.

NOTICE:
·

Make sure to put the backside of the V-ribbed belt on the V-ribbed belt tensioner assembly pulley and No. 2 idler pulley sub-assembly.

·

Check that the V-ribbed belt is properly set to each pulley.




b.

Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.


c.
A314804C01
0.552,1.167 0.719,1.333 0.167,0.167 10 false *a 2.198,1.167 2.365,1.333 0.167,0.167 10 false *b
*a Correct
*b Incorrect


After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.


Hide 53736 2.INSTALL FRONT FENDER APRON SEAL RH

Hide 3.INSTALL FRONT WHEEL RH