11301C
1.INSTALL TIMING CHAIN CASE OIL SEAL
| *a | Oil Seal Protrusion Height |
Apply MP grease to the lip of a new timing chain case oil seal.
Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover assembly edge.
0 to 1.0 mm (0 to 0.0394 in.)
Keep the lip free from foreign matter.
Do not tap in the timing chain case oil seal at an angle.
13471
2.INSTALL CRANKSHAFT PULLEY
Align the pulley set key with the key groove of the crankshaft pulley.
| *a | Hold |
|
Turn |
Using SST to hold the crankshaft pulley in place, tighten the crankshaft pulley set bolt.
16361A
3.INSTALL V-RIBBED BELT
4.INSPECT FOR ENGINE OIL LEAK