Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Radio and Display Type) › from 2016.11
RM3160E _56 Audio / Visual / Telematics _019701 NAVIGATION / MULTI INFO DISPLAY _0101135 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  AVC-LAN Circuit  


DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN communicates via AVC-LAN communication.

If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible.

WIRING DIAGRAM

E354630E03
0.906,3.396 2.958,3.604 2.052,0.208 10 false : AVC-LAN Communication Line 4.854,2.01 5.229,2.208 0.375,0.198 10 false F71 4.854,0.323 5.229,0.521 0.375,0.198 10 false F72 4.771,2.823 7.156,3.031 2.385,0.208 10 false Radio and Display Receiver Assembly 1.49,2.958 4.448,3.198 2.958,0.24 10 false Stereo Component Amplifier Assembly*2 1.5,2.802 1.802,2.99 0.302,0.188 10 false F76 2.396,2.021 2.708,2.198 0.313,0.177 10 false TX+ 2.427,2.406 2.771,2.583 0.344,0.177 10 false TX- 4.958,1.813 5.146,2.031 0.188,0.219 10 false 7 2.719,1.896 2.906,2.094 0.188,0.198 10 false 8 5.24,2.021 5.667,2.219 0.427,0.198 10 false TX1+ 5.24,2.438 5.583,2.625 0.344,0.188 10 false TX1- 4.958,2.229 5.135,2.417 0.177,0.188 10 false 8 2.729,2.281 2.865,2.438 0.135,0.156 10 false 7 1.417,1.219 2.844,1.417 1.427,0.198 10 false Parking Assist ECU*1 1.417,1.052 1.833,1.229 0.417,0.177 10 false F131 5.229,0.323 5.594,0.5 0.365,0.177 10 false TX3+ 5.24,0.729 5.625,0.896 0.385,0.167 10 false TX3- 4.948,0.125 5.063,0.302 0.115,0.177 10 false 7 4.948,0.531 5.094,0.708 0.146,0.177 10 false 8 2.396,0.323 2.708,0.5 0.313,0.177 10 false TX+ 2.406,0.719 2.698,0.896 0.292,0.177 10 false TX- 2.708,0.188 2.906,0.365 0.198,0.177 10 false 10 2.719,0.583 2.917,0.76 0.198,0.177 10 false 9 4.594,3.427 5.896,3.646 1.302,0.219 10 false *2: for 12 Speakers 4.583,3.167 7.052,3.385 2.469,0.219 10 false *1: w/ Panoramic View Monitor System 4.865,0.729 5.24,0.927 0.375,0.198 10 false F72 4.865,2.427 5.24,2.625 0.375,0.198 10 false F71

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for Radio and Display Type)>PRECAUTION



HINT:

The radio and display receiver assembly is the master unit.


PROCEDURE

1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
a.

Remove the radio and display receiver assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>REMOVAL


b.
E221758C38
1.302,1.844 1.635,1.229 false 2.146,1.823 1.76,1.208 false 0.104,0.104 1.177,0.302 1.073,0.198 10 false *a (*A) 1.146,1.865 1.5,2.094 0.354,0.229 10 false TX1- 2.094,1.844 2.552,2.042 0.458,0.198 10 false TX1+
*A for 12 Speakers
*a Component without harness connected
(Radio and Display Receiver Assembly)


E286972C10
1.417,0.917 1.833,1.167 0.417,0.25 1.865,2.229 1.635,1.771 false 1.302,2.219 1.49,1.76 false 0.135,0.125 0.635,0.396 0.5,0.271 10 false *a (*A) 1.833,2.271 2.448,2.469 0.615,0.198 10 false TX3+ 1.135,2.25 1.75,2.448 0.615,0.198 10 false TX3- 1.5,0.969 2,1.24 0.5,0.271 10 false F72
*A w/ Panoramic View Monitor System
*a Component without harness connected
(Radio and Display Receiver Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F71-7 (TX1+) - F71-8 (TX1-)*1 Always 60 to 80 Ω
F72-7 (TX3+) - F72-8 (TX3-)*2 Always 60 to 80 Ω


*1: for 12 Speakers

*2: w/ Panoramic View Monitor System



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)
a.

Disconnect the F71 and F72 radio and display receiver assembly connector.


b.

Disconnect the F76 stereo component amplifier assembly connector (for 12 Speakers).


c.

Disconnect the F131 parking assist ECU connector (w/ Panoramic View Monitor System).


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (for 12 Speakers):
Tester Connection Condition Specified Condition
F71-7 (TX1+) - F76-8 (TX+) Always Below 1 Ω
F71-8 (TX1-) - F76-7 (TX-) Always Below 1 Ω
F71-7 (TX1+) or F76-8 (TX+) - Body ground Always 10 kΩ or higher
F71-8 (TX1-) or F76-7 (TX-) - Body ground Always 10 kΩ or higher


Standard Resistance (w/ Panoramic View Monitor System):
Tester Connection Condition Specified Condition
F72-7 (TX3+) - F131-10 (TX+) Always Below 1 Ω
F72-8 (TX3-) - F131-9 (TX-) Always Below 1 Ω
F72-7 (TX3+) or F131-10 (TX+) - Body ground Always 10 kΩ or higher
F72-8 (TX3-) or F131-9 (TX-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT MALFUNCTIONING PARTS

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT MALFUNCTIONING PARTS
a.

Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

HINT:
·

Check all slave units.

·

If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.



OK:

Master unit returns to normal operation.



Result:
Proceed to
OK
NG



OK

REPLACE MALFUNCTIONING PARTS

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY